From Newsgroup: rec.games.pinball
On 2020/08/11 12:29 p.m.,
Dlej@comcast.net wrote:
Just to let anyone reading this thread later on: the PBL brackets are about 1/8” too short and do not sit flush with the playfield surface. Unfortunately there does not appear to be a good replacement available. In order to make these work properly you will probably have to rout down the underside of the playfield so they sit flush.
Dan L
Hi Dan,
Did the NOS one you got from us work properly? I still have some of
those in blue, sold out completely in white though.
It looks a bit too big to run through our benchtop injection mold
machine, if I could even afford to make the mold! My machine tops out at 2 oz of plastic...
Mold cost is what is holding back reproduction of many of these parts - typically a two part mold starts around $1500USD and multipart molds go
up fast from there.
I guess the question is, is there enough of a market for some of these
older plastic parts (not 3D printable due to strength requirements) for
a GoFundMe compaign or would that fall flat on its face?
John :-#)#
--
(Please post followups or tech inquiries to the USENET newsgroup)
John's Jukes Ltd.
MOVED to #7 - 3979 Marine Way, Burnaby, BC, Canada V5J 5E3
(604)872-5757 (Pinballs, Jukes, Video Games)
www.flippers.com
"Old pinballers never die, they just flip out."
--- Synchronet 3.18a-Linux NewsLink 1.113